Page 1 of 1

Possible pitfalls using FAST MIRROR

Posted: Tue Jan 02, 2018 9:19 pm
by rgdudley
I am just wondering what possible problems I might run into using fast mirror for backing up a external hard drive containing 30 thousand pictures. Currently I make two backups using mirror without the FAST option. I recall having had some problems using that option in the past.

Re: Possible pitfalls using FAST MIRROR

Posted: Fri Jan 05, 2018 1:12 pm
by Support
Hi,

There should be no problems. The Fast Mirror will back up only new and modified files from sources. That will result in a faster backup.

Re: Possible pitfalls using FAST MIRROR

Posted: Fri Jan 05, 2018 10:25 pm
by rgdudley
I guess I am wondering if I delete some files from the source disk, will those also be deleted from the destination disk using the fast option. I think that was the problem I had in the past. I would want them to be deleted from the destination so it is an exact copy of the source.

Richard

Re: Possible pitfalls using FAST MIRROR

Posted: Tue Jan 09, 2018 10:05 am
by Support
Hi,

If you want to also remove from destination the files deleted from sources, you need to select the "Remove excluded or deleted files" option from Backup Properties->Type->Mirror.

Re: Possible pitfalls using FAST MIRROR

Posted: Tue Jan 09, 2018 3:20 pm
by rgdudley
Great. Thanks.

I also assume that any alterations made to the destination outside of backup&4all will not be noticed by b4a when using the fast option.

Re: Possible pitfalls using FAST MIRROR

Posted: Thu Jan 11, 2018 11:39 am
by Support
Hi,

Yes, that is correct. Backup4all won't monitor the destination all the time, to track any change made outside Backup4all.
It is supposed you won't manually alter the backup in destination.

Re: Possible pitfalls using FAST MIRROR

Posted: Tue Jan 23, 2018 4:06 pm
by rgdudley
OK. I have been using fast mirror and it seems to save hours of time.
Now can backup in a few minutes rather than several hours... so I backup more frequently! That's good.

However, I understand that at some point I should make a full backup without the FAST option... to get all files rewritten occasionally... is that reasonable?

If so what is the best way to do that without confusing the "catalog" of the FAST option approach.

Should I just use the same backup set and occasionally turn off the fast option, or should I create a different backup set (without fast) and run that occasionally.

What is the best and safest protocol? :?: